How To Use PC Pursuit Service ----------------------------- Placing a PC Pursuit Call ------------------------- * Use a modem to dial your local Telenet access telephone number with parameters settings of 8-N-1. * Type two CARRIAGE RETURNS (CR) D (CR) Telenet Prompt User Input Comments ====================================================================== (1) Terminal = D1 (CR) Input Terminal ID. D1 is typical for PC's. If not known, type CR. (2) @ C D/NYNYO/12,YOUR ID (CR) Type area code desired, modem speed and your user ID. (Note that /3 = 300 bps, /12 = 1200 bps, /24 = 2400 bps). (3) PASSWORD = PASSWORD (CR) Enter user Password (4) D/NYNYO/12 Connected to target CONNECTED city outdial modem. (5) ATZ Type ATZ (in upper case) (6) OK Modem responds as cleared. (7) ATDT 7654321 Type ATDT (in upper case) and the 7-digit number you wish to dial. (8) CONNECT (CR) (CR) You are now connected to the computer that you dialed. Procees as if the number was dialed directly. NOTES: ----- 1. If the connection was not made, a BUSY will be seen within 30 seconds. The BUSY message means that the number dialed was either busy, not in service, or an invalid attempt to dial more than 7 digits. A BUSY will also be seen after disconnecting from the host computer, but you can dial another number by starting again at the fifth step and typing ATZ and dialing the number. 2. PC Pursuit uses standard HAYES dialing commands, which enable you to type the A/ (no CR) command to redial the previously dialed number. 3. When a typing mistake is made in the second and third steps, the log-on must be re-entered. To Disconnect from PC Pursuit ----------------------------- Telenet Prompt User Input Comments ====================================================================== (CR) @ (CR) Escape to Telenet command level. @ D (CR) At the @ sign,issue disconnect command. D/NYNYO/12 Disconnect from the DISCONNECTED target city complete. User is still connected to Telenet at the local dial-up city. A PC Pursuit can now be placed to another city. NOTES: ------ 1. To DISCONNECT FROM TELENET, log off your computer as usual, or hang-up. Downloaded From P-80 Systems 304-744-2253