ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º Adaptec, Incorporated ACB-2310,12 º ÌÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͹ º J6 J9 J10 J3 J4 J5 J1(2312) º º ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ º º ³ ³³³³ :::::1 1: 1: 1: 1: ³ÉÍÍÍ º º ³ :: :: :: :: ³º º º ³ 123 :: :: :: :: ³º º º ³ ::: :: :: ³º º º ³ 456 :: :: ³º º º ³ ³º º º ³ ³º º º ³ ³º º º ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ Ú¿ ÚÄÄÙº º º ÀÄÄÄÄÄÄÄÙÀÄÄÄÄÄÄÄÄÄÄÄÄÙ º º º INTERFACE: ISA(AT)->ST412(MFM) º º CONTROLS: 2 Floppy Drives (2312 only) (360KB, 720KB, 1.2MB, 144MB) º º 2 Hard Drives º º º º J9: Option Jumpers: 1: Disable I/O Waite State ¿ º º 2: Track-1 ReCal., Step=35us. ³Default º º 3: (Not Used) ³Setting is º º 4: Serial Monitor Mode ³NO JUMPERS º º 5: Diagnostics Enable ³installed. º º 6: (Reserved) Ù º º º º J10: I/O Addresses: Hard Drive: *Primary Address (1F0H): OFF º º Secondary Address (170H): 4-5 º º º º Floppy Drive: *Primary Address (3F0H): OFF º º Secondary Address (370H): 1-2 º º º º J1: Floppy Drive (2312 only) (* Default setting) º º J5: HD Control º º J4: HD0 Data º º J3: HD1 Data º º J6: HD LED º ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ADDITIONAL INFO ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄĶ º º º According to the Manufacturer, the ACB-2310/12 is 100% software and º º hardware compatible with the WD1003-WA2, but you are advised to do º º a Low Level Format to take advantage of the improved 1:1 Interleave º º that this controller offers. Note that there is no on-board BIOS, º º so no DOS Debug LLF option is available. Third party Formatting º º software is required, ie; Disk Manager(tm) or SpeedStor(tm). º º º º º º º º º º º º º º º º º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ